wphase:documentation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
wphase:documentation [2018/03/04 13:47] wphase |
wphase:documentation [2018/05/03 16:56] wphase [RUNA scripts] |
||
|---|---|---|---|
| Line 37: | Line 37: | ||
| setenv RDSEED /path/to/rdseed/executable | setenv RDSEED /path/to/rdseed/executable | ||
| setenv GF_PATH /path/to/greens/functions/database | setenv GF_PATH /path/to/greens/functions/database | ||
| - | setenv WPHASE_HOME /path/to/wphase/package | + | setenv WPHASE_HOME /path/to/wphase |
| </code> | </code> | ||
| If you use bash: | If you use bash: | ||
| Line 123: | Line 123: | ||
| $WPHASE_HOME/bin/wpinversion -ifil o_wpinv.th1.3 -ofil o_wpinv.th0.9 -th 0.9 | $WPHASE_HOME/bin/wpinversion -ifil o_wpinv.th1.3 -ofil o_wpinv.th0.9 -th 0.9 | ||
| </code> | </code> | ||
| - | - Finally, it is possible to remove the channels showing a large rms ratios (observed/predicted and predicted/observed) using the option –nr (e.g. –nr 2.0): <code> | + | - Finally, it is possible to remove the channels showing a large rms amplitude ratios (observed/predicted and predicted/observed) using the option –nr (e.g. –nr 2.0): <code> |
| $WPHASE_HOME/bin/wpinversion -ifil o_wpinv.th0.9 -ofil o_wpinv.th1.3 -nr 2.0 | $WPHASE_HOME/bin/wpinversion -ifil o_wpinv.th0.9 -ofil o_wpinv.th1.3 -nr 2.0 | ||
| </code> | </code> | ||
| Line 145: | Line 145: | ||
| will perform median and rms misfit screening for Z channels only. | will perform median and rms misfit screening for Z channels only. | ||
| - | These two scripts don’t perform the “ratio screening” (i.e. 3. above). To run the same routines with an additional screening based on the ratio (observed/predicted and predicted/observed), the following scripts can be used: | + | These two scripts don’t perform the “ratio screening” (i.e. 3. above). To run the same routines with an additional screening based on the rms amplitude ratio (observed/predicted and predicted/observed), the following script can be used: |
| <code> | <code> | ||
| ${WPHASE_HOME}/bin/RUNA3r.csh | ${WPHASE_HOME}/bin/RUNA3r.csh | ||
wphase/documentation.txt · Last modified: 2022/01/10 07:39 by wphase
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
